SATTOOLS 花45元钱买来的！

469375079 · 发表于 2010-4-21 00:01:14

希望对你们有用！！[s:166]

jyyf · 发表于 2010-4-21 02:59:02

看哈是啥东东.....................

jackwei057 · 发表于 2010-4-21 07:08:11

什么东西啊，

syzdq · 发表于 2010-4-21 08:39:01

20年前的东西吧？现在的SEATOOLS升级了不知道多少次了。
大家看下它的README：

*****************************************************************
      README.DOC
Disk Technician Factory Test for Seagate Drives Version 1.22
  This test correlates to Seagate Disk Repair Center testing.

This document contains information about major changes which have
been included in this new version.
*****************************************************************
TABLE OF CONTENTS:

1.0 Most Drives Now Automatically Recognized and Tested.
2.0 Defective Media Locations Now Automatically Removed From
   Service.
3.0 User's Guide Now On Diskette -- How To Print A Copy.
*****************************************************************

1.0 Most Drives Now Automatically Recognized and Tested.

   Virtually all Seagate IDE, SCSI, SCSI-1, SCSI-2, Fast
   SCSI-2 and ST506/412 (MFM/RLL) drives will now be
   automatically recognized and tested by Disk Technician
   Factory Test For Seagate Drives version 1.22.

   This will greatly enhance the value of Factory Test in
   eliminating No Problem Found (NPF) drives in the field.

   Please refer to Appendix A in the file MANUAL.DOC
   (included in the Factory Test software files) for a
   complete listing of eligible drives, plus the matching
   controller or adapter recommended for testing each drive.

2.0 Defective Media Locations Now Automatically Marked Bad.

   Many Factory Test users requested that we add the ability
   to automatically mark-out any media defects detected by
   Factory Test's "Quick Test" and/or "Media Certification."

   Version 1.22 adds this important feature.

   Once testing has finished, any media defect locations
   identified by Factory Test (as shown in the "Quick Test
   Report" and/or "Media Defect Report") can be automatically
   marked "bad" and removed from service. To do this, simply
   high-level format the drive under the desired operating
   system (DOS, UNIX, Macintosh, etc.).

3.0 User's Guide Now On Diskette -- How To Print A Copy.

   In order to put changes into effect more rapidly, the
   User's Guide is now contained in a file called MANUAL.DOC
   and is included on the Factory Test diskette.

   To print a copy of the User's Guide, type the following
   from the system prompt:

COPY  A:\MANUAL.DOC  PRN

   and then press the Enter key (be sure the printer is on
   and connected).

*******************************END*******************************