WD800BB-00HEA0换板后无法识别，会的指点一下

chenlin189 · 发表于 2010-3-22 22:29:04

小弟有两个西数的硬盘，正好一个是盘体坏了，一个是pcb板坏了，大小容量全一样，产地一样，只有dcm有些不同，生产日期差了几天，换了板后，正好rom是可写的，就把坏的pcb上的rom写到好的pcb板上，但是还是无法被正确的认出，接到pci3000上，有报错如下：
Techno mode key:
Techno mode key:........................ : Techno key error Drive is not ready

RAM:
Zone allocation table................... : HDDs RAM reading error Techno CMD sending error Drive is not ready

Head number reading..................... : Ok
Heads number............................ : 2

ROM:
ROM reading............................. : Ok
Heads configuration..................... : by map
Heads number............................ : 2
Heads number in use..................... : 2
Switched off heads...................... : No
Head map................................ : 0,1

Service area:
SA dir reading.......................... : Ok (Copy 0)
Configuration reading................... : Ok
Master Password......................... : has not been set
User Password........................... : has not been set

固件检测全部正常，就是我想是那两个报错导致无法被正确识别的，会的指点一下，是不是换板非要把rom换了才行，刷的rom不行？？