西数不认盘，无法访问固件

hongfanshuju · 发表于 2014-5-28 14:42:42

WD1600BEVS的盘，能就绪，不认盘，访问不了固件，磁头确定是好的，做热交换读不了故障盘的模块，大家帮忙看看该怎么搞？

Techno mode key
Techno mode key......................... : Ok

RAM:
HDD Info reading........................ : Ok
Heads number............................ : 4
Cyl Count............................... : 96

Zone allocation table................... : HDDs RAM reading error - Device Error Detected: "VSCE PERM OVL NOT LOADED. LDR Upload is recomended"

ROM:
ROM reading............................. : Ok
ROM Data size........................... : 192 Kb
ROM version............................. : 11.86H
ROM generation.......................... : 11.86H
Link table version...................... : 03.8F.
Consolidated ROM version................ : 00110086

ROM Modules:
Flash ROM dir reading................... : Ok
SA regions address...................... : by default
SA Translator loading................... : Ok

Heads configuration..................... : by map
Heads number............................ : 4
Heads number in use..................... : 4
Switched off heads...................... : No
Heads map............................... : 0,1,2,3
ROM Firmware version.................... : 00110086

Service area:
Permanent overlay....................... : Not loaded
SA dir reading (ID)..................... : DISK ECU UNSAFE ERROR
SA SPT Detect........................... : FAIL
SA dir reading (ABA/CHS)................ : Dir reading error ABA 65536 reading error Physical read error C/H/S: -96/1/1 - Device Error Detected: "DISK ECU UNSAFE ERROR"
SA Access............................... : NONE

Configuration reading................... : Module 02 not found