三星2T硬盘磁头是好的敲盘

夕阳无限好丶 · 发表于 2014-5-13 18:26:27

yshdata 发表于 2014-5-13 17:50
三星的台式机硬盘的 COM口用需要用希捷3.5存 IDE接口盘的大头COM 代替即可

这是硬盘显示的信息
ctiveFW : 00
FWVer : 0001
SATA PLL cal done

DDR size detected = 32MB
*PA VID=0000 PN=0009 Rev=0001- 785x Found
*PA VID=0000 PN=0009 Rev=0001- 785x Found
U
S_0
RV Sensor Circuit Enabled
Shock Sensor Circuit Enabled
SO_1
RPM at Handoff: 3526
Temp : 32 degC
SpinOk
mS1 00000003
SK C:104976 H:0
Loaded FIT ( 0: 0: 1)
CalibTable Loaded. Rev:0x1B
Selective MARC NX Loaded
ResoTable Loaded. Rev:0x01
RRO1xTable Loaded. Rev:0x01
Fw Active 0000
Ovly loaded to 0x00014D00
Ovly loaded to 0x1002E300
FdtTable Loaded. Rev:0x02
Reading Serial Num Pass
Up MC
| 159 | DISK_ID  | 51 | 0 |  300 | B98B |
| 159 | DISK_ID  | 51 | 1 |  300 | B98B |
| 159 | DISK_ID  | 51 | 2 |  300 | B98B |

PwrOn RRO1x @ H0
Table) cos = 1792, sin = 2816
Coeff) cos = -17902, sin = 13383

PwrOn RRO1x @ H2
Table) cos = 512, sin = 2560
Coeff) cos = -17575, sin = 883

AP:2 C:  2500->  2500 H:2->4 AP Cnt: 0
UF 3 1stGrayErr Hd:4
UF4 1VE
UF6 GE
UF 3 1stGrayErr Hd:1
VOP!
PK_3 C:    3 H:0
SK C:105054 H:1
AP:1 C:105054->  2510 H:4->4 AP Cnt: 1
UF4 1VE
SK C:101213 H:5
AP:1 C:101213->  2520 H:4->4 AP Cnt: 1
UF4 1VE
SK C: 99228 H:5

PwrOn RRO1x @ H4
Table) cos = 768, sin = 768
Coeff) cos = 11, sin = 109

RRO1xCheckPwrOn Fail
TgtCyl: 2032
AP:1 C: 99228->  2530 H:4->4 AP Cnt: 1
UF4 1VE
SK C: 99930 H:5
Hd: 0 Zn: 0 Avg.:- 130
TgtCyl:  264688
Hd: 0 Zn: 1 Avg.:    70

SVCAL(0080,0000)-->PASS
RecordValid Ok : 0C07E47D 0007E41D
ReadyTime = 5198561 us
ENG>

现在只要操作4号头就敲盘其他头正常