编辑ID时ASCI3C老是不行

lkhak47 · 发表于 2009-12-23 00:13:39

ST380013AS的盘用STR7200.7demoF级校准后，回写ATA正常，在编辑ID时ASCI3C老是不行，不知是啥问题啊，我已经开过2次F级校准了，看站里的贴说F级校准后还要T级下N2,,22,还要校一次？
头痛了。大家帮忙看看，出出主意。
SetStuff->ASCIFE
Setting stuff to defaults
T>F
SetStuff->ASCI1B5354333830303131415320202020202020202020202020202020202020202020
2020202020202020
Stuff key 1b -> 53 54 33 38 30 30 31 31 41 53 20 20 20 20 20 20 20 20 20 20 20 2
0 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20
T>F
SetStuff->ASCI83F8B00950
Stuff key 83 -> f8 b0 09 50
T>F
SetStuff->ASCI3CF8B00950
T>4.06  04-16-03 16:50
(P)PATA Reset
Slaventerface task reset
4096k x 16 buffer detected
ALPINE - 1_Disk S.15  01-16-03 11:51
Head Mask 000F - Switch to full int.
            Spin Ready
4.06  04-16-03 16:50
(P)PATA Reset
Slave
Cmd Cyl Hd Sct  Cnt  Stbuf Segl Csct Cbuf Actv Ercd Rtry Flags
44  00000 0D 0B00 0000 E800  E0 0007 3FFE  N 00  9F75.2F.40  00
Age=50 Type=21 MxCyl=16358 MxHd=1 MxSct=44C BSz=0000 TCode=0000
Pgm=00 Trk=0EFB7(0EFB7).0(0).007(006) Zn=0 Err=00 ErCt=0000 Hlth=1008 CHlth=0000
Ready LBA=00000000