ST .9 CERT问题

asbule · 发表于 2009-4-13 22:45:26

ST .9 F级 LDR引导后回T
#
N2后报错

T>#
Enter Drive S/N 9ND145HP
Enter Packwriter S/N
T>N2,,22
T>

************* Cert Log Cyls inadequate. 0005 more cyls required
DiskAccess ReadSector EC=47 at ffffffff.00.0000
DiskAccess ReadSector EC=47 at ffffffff.00.0000
INVALID Cert Disk Code - ROM Resident Revision Required: 3.AAH
Command Inactive - No VALID Cert Code Detected

[ 本帖最后由 asbule 于 2009-4-13 23:07 编辑 ]

asbule · 发表于 2009-4-13 23:03:55

2048k x 32 SDRAM
TONKA15 - 1_Disk S.68 03-14-06 11:17
Head Mask FFFF - Switch to full int.
Spin Ready
ERR Read App Code

F>
T>#
Enter Drive S/N 9ND145HP
Enter Packwriter S/N
T>N2,,22
T>

************* Cert Log Cyls inadequate. 0005 more cyls required
DiskAccess ReadSector EC=47 at ffffffff.00.0000
DiskAccess ReadSector EC=47 at ffffffff.00.0000
INVALID Cert Disk Code - ROM Resident Revision Required: 3.AAH
Command Inactive - No VALID Cert Code Detected

T>

[ 本帖最后由 asbule 于 2009-4-13 23:10 编辑 ]

LIANG747597479 · 发表于 2009-5-7 17:39:43

加载LDR不好啊

asbule · 发表于 2009-5-7 20:06:50

初始化下后，可以跑SF了~

nghiahieph · 发表于 2009-5-7 20:38:39

you tried load app code ???
you can borrow app code from other hard disk
firmware 3.aah load very long ,,about 30 minutes
lucky !!!!![s:14]

jsnwj · 发表于 2016-12-20 09:00:21

you tried load app code ???
you can borrow app code from other hard disk
firmware 3.aah load very long ,,about 30 minutes
lucky !!!!![s:14]

你加载 app code 了吗？
你可以从其他硬盘获得app code。
固件3.aah 加载时间较长，大约要30分钟。
祝你走运！！！[s:14]

[求助] ST .9 CERT问题